HIGH PERFORMANCE CLEAR SEALER FOR DRIVEWAYS AND CONCRETE SURFACES.
Drive dries to a high gloss ‘wet look’ clear finish and provides a smooth washable surface, protecting from stains, spills and reducing the ability of moulds, algae and lichen to discolour the surface.
Drive is well suited to protecting new surfaces or restoring aged and faded concrete, stencilled, patterned and stamped concrete.
Re-seal every 18 - 24 months is recommended to keep your concrete looking great.
- Garage floors
- Stencilled and spray on cement based resurfacing mixes
- Rapid Dry
- Excellent penetration and adhesion
- May be tinted
MOISTURE TEST - IMPORTANT
A simple moisture test is to tape a small square of cling film or plastic to the concrete and leave for an hour or so. If there is no condensation or moisture the surface is generally safe to seal. Note that in colder temperatures, moisture may not be evident.
Hand held sprayers are prone to breakdown as rubber and plastic parts soften as they encounter the solvent.
Apply in well ventilated areas only.
The use of glasses and gloves is recommended to protect the eyes and skin during application.
Drive cures and hardens as the solvent evaporates from the coating. In hot temperatures rapid drying can be problematic and we recommend application early in the day to avoid hot surfaces.
Additional solvent can be added to assist application over hot surfaces or in hot conditions.
Gloss levels are affected by cleaners and other environmental factors and a loss of gloss is to be expected over time, although the sealer will continue to protect your concrete.
Avoid washing cars or using waxes or detergents on your sealer as these may lead to build up and make re-sealing more difficult.
|No. of Coats||2 - 3|
|Coverage Rate||1L = approx. 6 - 7m²|
|Drying Time||Recoat: 2 - 4 hours|
|Dry: 24 - 48 hours|
|Fully Cured||3 Days|
|Shelf Life||24 months|
|Application Temp.||5°C - 35°C|
|Application Method||Brush, Broom, Roller or Sprayer|
Extreme temperatures can affect the finished product. We do not recommend the use of Drive where surface temperatures exceed 50°C. For example; outdoor dark slate areas, or slate areas around open fireplaces.
*Please note that Drive is classed as a Dangerous Good and International Shipping is not available for this product.
Customers are advised to consider the information in this data sheet in the context of how the product will be used, including surfaces and any other products used. The information provided in this data sheet represents our best scientific and practical knowledge. Any advice, information or assistance provided by Shalex in relation to its products is given in good faith, however, is provided without liability or responsibility. Due to the wide variety of site conditions we are unable to assume liability for any loss that may arise from the use of our products. The user is responsible for checking the suitability of products for their intended use.